Handheld Remote Control Assembly. Pgs - Craftmade Fleming Guide D'installation

9. Light Kit Assembly. (cont.)
If you do NOT wish to use the light kit,
slots on metal cover and align with nodules
inside LED light kit. Gently push up on metal
cover and turn to the
no longer turns.
WARNING: Do NOT connect the molex
connections for the LED light kit if you do NOT
wish to use the light kit.
WARNING: Metal cover will be HOT if light is left
on.
10. Handheld Remote Control
Assembly.
IN ORDER TO USE THE HANDHELD REMOTE
CONTROL, PLEASE CONTINUE WITH SECTION 10 for
remote control assembly instructions. If you have
already installed the wall control but do not wish to
use the handheld remote control, please proceed to
Section 11.
Gently pull on remote control cover to separate
top and bottom parts. [Refer to diagram 1.]
In order to use wall control as a handheld remote
control, cut each wire on wall control (that was
not previously used)--use wire cutters to cut off
each wire as close to the wall control as possible.
[Refer to diagram 2.]
Install one 12-volt battery (included) in wall
control. [Refer to diagram 2.]
The dimmer switch (labeled ON and D) has been
pre-set to the "ON" position (ON). If you do not
wish to have dimming capability, please move
the switch to the "OFF" position (D). [Refer to
diagram 2.]
Align holes in wall control with posts located on
inside of TOP part of remote control cover and
press together firmly. Place wall control into
BOTTOM part of remote control cover, aligning
posts in top of remote control cover with post
holes in the bottom. [Refer to diagram 3 on the
next page.]
["Handheld Remote Control Assembly"
continued on next page.]
locate
RIGHT (clockwise) until it
diagram 1
dimmer
switch
diagram 2
page 9
nodules
grooves
metal
cover
remote control
cover
(top)
(bottom)
wall control
wire
III IV
II V
VI
I
wire
12V battery
wire