Blade Assembly; Light Kit Assembly. Pgs - Craftmade Fleming Guide D'installation

8. Blade Assembly.

WARNING: To reduce the risk of serious bodily
injury, DO NOT use power tools to assemble the
blades. If screws are overtightened, blades may
crack and break.
Locate 32 blade attachment screws and washers in
one of the hardware packs. Place blade arm on
UNDERSIDE of blade, aligning holes in blade arm
with holes in blade as shown. Insert 4 blade
attachment screws (along with washers) from
TOPSIDE of blade with fingers first and then tighten
screws securely with a Phillips screwdriver. Repeat
procedure for remaining blades.
Locate blade arm screws/washers in hardware pack.
[If plastic motor locks are installed with blade arm
screws, discard plastic motor locks.] Align blade
arm holes with motor screw holes and attach
blade arm with blade arm screws/lock washers.
Before securing screws permanently, repeat with
remaining blade arms. Securely tighten all screws.
NOTE: Tighten blade arm screws twice a year.
9. Light Kit Assembly.
Remove 1 screw from motor plate on underside of
motor housing and partially loosen the other 2
screws. Align slotted holes in fitter plate with
loosened screws in motor plate, allowing molex
connections from motor housing to come through
holes in midde of fitter plate. Twist fitter plate to
lock. Re-insert screw that was just removed and
securely tighten all 3 screws with a Phillips
screwdriver.
Remove 1 screw from underside of fitter plate and
partially loosen the other 2 screws.
Connect WHITE wire from LED light kit to WHITE
wire from motor housing. Connect BLACK wire
from LED light kit to BLACK (or BLUE) wire from
motor housing. Be sure that molex connections
snap together completely.
Carefully arrange wiring within fitter plate. Align
slotted holes in LED light kit with loosened screws
in light kit fitter. Twist LED light kit to lock. Re-insert
screw that was previously removed and tighten all
3 screws securely.
Align grooves on shade with nodules on inside of
LED light kit and push up gently on shade. Twist
shade to the RIGHT (clockwise) until shade locks
into place.
Pull down VERY GENTLY on shade to make sure that
shade is secure.
["Light Kit Assembly" continued on next page.]
blade arm screws/
lock washers
molex
connections
page 8
motor
housing
blade attachment
screws and washers
blade
blade arm
motor housing
motor plate
fitter plate
motor housing
fitter plate
LED light kit
nodules
shade
grooves