Craftmade Garrick Guide D'installation page 7

6. Wiring.
WARNING: Turn off circuit breakers to current fixture from
breaker panel and be sure switch is turned to the OFF
position.
CAUTION: Be sure outlet box is properly grounded and that
a ground wire (GREEN or Bare) is present.
Make sure all electrical connections comply with Local Codes
or Ordinances and the National Electrical Code. If you are
unfamiliar with electrical wiring or if the house/building
wires are different colors than those referred to in the
diagram to the right, please use a qualified electrician.
Note: Excess lead wire length from the fan can be cut to the
desired length and then stripped.
WARNING: If using this fan in a WET location, this fan
must be connected to a supply circuit that is protected by
a Ground Fault Circuit Interrupter (GFCI) to reduce the risk
of personal injury, electrical shock or death.
When downrod is secured in place on the hanging
bracket, WIRE THE RECEIVER with wire connectors
provided as shown in diagram at right.
Tip: While you are wiring, keep in mind that wires must
not obstruct receiver from sliding into hanging bracket.
* Wrap each wire connector separately with electrical
tape as an extra safety measure.
Gently insert receiver (flat side up) into hanging bracket
and carefully push taped wire connectors into outlet box.
Allow antenna from remote control receiver to hang
outside of hanging bracket.
[PLEASE NOTE: Wall and/or handheld remote control
must be used for fan to operate. If you do not wish to use
the wall control, please proceed to Section 7, page 8 to
continue with fan installation.]
To install wall control, remove existing wall switch. Wire
one of the wall controls with wire connectors provided as
shown in diagram at right.
*Wrap each wire connector separately with electrical tape
as an extra safety measure. Gently push wires and taped
wire connectors into outlet box.
Install one 12-volt battery (included) in wall control.
IMPORTANT: Wall control will not function unless battery
is installed.
Since this fan comes with dimmable LED bulbs, the
dimmer switch (labeled DIM and ON) has been pre-set to
the "ON" position (DIM). If you do not wish to have
dimming capability, please move the switch to the "OFF"
position (ON).
Select a faceplate (almond or white) and press firmly onto
front of wall control. Attach wall control to outlet box and
secure with screws from original wall switch. Attach plate
(included) to wall control using 2 screws provided with
the wall control.
white supply wire
black supply wire
blue
black
white
from fan
from receiver
white
black
blue
(wiring for receiver)
outlet box
green/ green/ green/
bare bare bare
ground ground ground
black
black
(AC IN from
breaker box)
(wiring for wall control)
page 7
ground (green
or bare)
ground (green
black
from ceiling
from receiver
black
AC IN L
white
AC IN N
receiver
antenna
wall
control
- 1 1
green
DIM ON
black (OUT to fan)
black
(TO POWER supply)
12V battery
or bare)
*
dimmer
switch
face-
plate
plate