Lanaform S2 Mode D'emploi page 3

Masquer les pouces Voir aussi pour S2:

Les langues disponibles

• This device should not be used by young children, people who are insensitive to heat or on animals.

• The device should not be used on a folding bed or on a bed, a section of which can be adjusted.

• Examine the device frequently to check for any signs of damage to the product or signs of wear.If you notice signs of

wear or damage, stop using this product immediately and take it back to the supplier or the its after-sales department.

USING THE HEATING PAD

Diagram and description:

1) OFF button

2) Position "1" (1st setting)

3) Position "2" (2nd setting)

4) Position "3" (3rd setting)

5) Display screen

Operating the heating pad:

• Put the pad down flat on the bed.The light side of the heating pad should be against the mattress.The end of the pad

without the controller should be placed at the foot of the bed.

• Only put a sheet or fine cotton mattress over the pad so that you can feel the heat.

• Connect each plug to one of the two sockets on each side of the pad and the other end

to an electricity supply (AC220-240V).Make sure that there is a power socket nearby and

that the power cable is not in a position where the user may trip over it.

• To pre-heat the pad, select the third setting for 15 minutes.The temperature will

gradually rise.

• After pre-heating, get on to your heating pad and turn the control button to the heat

setting you require.If you use the pad for a long time or if you're going to sleep, select the

first setting.It will take about 15 minutes for the pad to reach the required temperature.

• To turn the device off, turn the button to the "Off" position.

Note:The heating pad is set to run continuously for three hours.If you wish to extend that time, it is

advisable to let the heating pad cool down first for 5 minutes before using it again.

CLEANING AND MAINTENANCE

When you are not using the heating pad and before cleaning it, follow the instructions below:

- Make sure the control button is in the "Off» position.

- Disconnect the power supply.

- Disconnect the plug linking the control to the device.

- Leave the pad to cool before cleaning.

Heating Blanket S2