Télécharger Imprimer la page

LightProcessor Q12 Mode D'emploi page 7

Publicité

Les langues disponibles

Les langues disponibles

•CHASES•
The Q12 can store twelve moving sequences (chases) along with the level applied to each channel during
programming. The chases are stored under the flash buttons. Two chases may be run simultaneously. A
total of 192 chase steps can be stored with a maximum of 64 steps in any one chase.
PROGRAMMING A CHASE
1. Select PROGRAM. Note that both the SCENE and CHASE LEDs flash.
2. Press the CHASE button and the SCENE LED goes off.
3. Select one of the twelve chase memories by pressing one of the 'flash' buttons.
4. Move the A sliders to the desired levels, then press the CHASE button to enter the selection as a step
in the chase.
5. Repeat step 4 for each chase step.
6. Select RUN when all the desired steps have been entered.
RUNNING A CHASE
1. Select RUN.
2. Press CHASE.
3. Press the 'flash' button in which the chase is stored and the chase starts to run.
4. Repeat steps 2 and 3 with a different flash button to run a second chase or with the same flash button
to stop the first chase.
5. Press CHASE twice to stop one or both running chases.
Q
12
6

Publicité

loading