Publicité
Les langues disponibles
Les langues disponibles
STREETLIGHT MINI
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precau ons should always
be followed including the following:
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
1. To avoid the possibility of electrical shock, turn off power supply before
installa on or servicing. Installa on and servicing should be performed
by qualified personnel.
2. When closing cover of fixture, be sure all wires are inside housing to
avoid pinching wires.
3. If Photo Receptacle is installed refer to "Photo Control" sec on for
Product must be installed in accordance with your local electrical code.
4. If you are not familiar with these codes and requirements, consult a
qualified electrician
5. Do not change the structure or any commponents of the fixture to
ensure safety.
SAVE THIS INSTRUCTIONS FOR FUTURE REFERENCE
1
Input wires
3
5
Cover
Allen Wrench*¹
2
4
Allen Wrench*²
*¹ Allen Wrench: 3mm
*¹ Inner Hexagon Screw: M4X8
*² Allen Wrench: 4mm
*² Inner Hexagon set Screw: M8X20
100-240V/277V AC, 50/60Hz, Suitable for Wet Loca ons (IP66), Class I
*Only suit for outdoor use. Max installa on height: 15M.
*Normal opera ng posi on is on a mast arm or post top .
Pole fi er diameter: Φ 60mm (2.4") / *48mm diameter need longer screws
*This product must be grounding
Power
Dimension
20-57W
447 x179 x77 mm
Input wires
Pole
Allen Wrench*²
Allen Wrench*¹
180°
INSTALLATION INSTRUCTIONS
EPA
0.096 m²
STANDARD MOUNTED
STEP 1:
Open the cover by 3mm allen wrench.
STEP 2:
Loosen the two screws by 4mm allen wrench.
Insert the power cord into the driver box and
then insert the pole to the luminaire. Ensure
the light-emi ng area face up.
STEP 3:
Connect the wrires into the terminal block.
Adjust the length of wires and then fix the
water-proof connector.
STEP 4:
Close the cover by 3mm allen wrench. Rotate
the luminaire by 180 degrees. Ensure the
light-emi ng area face down.
STEP 5:
Fix the luminaire on the pole by 4mm allen
wrench.
Weight
2.2 kg
Publicité
