Publicité
Les langues disponibles
Les langues disponibles
Post Assembly for Multiple Fixture Heads,
a. Assemble multiple fixture post by attaching lower post
section with upper post section, by threading lower post
section into break knuckle.
Upper
Post
Section
Post Cap
b. With post laying on its side, thread supply wire through post allowing
excess wire at top for wiring fixture head.
Post Cap
Attach Head:
a . Wire head to post as shown in diagram. Twist together white
wire(s) from fixture(s) to white supply wire using wire nut to secure.
Next, twist together black wire(s) from fixture(s) to black supply
wire using wire nut to secure. Connect ground wire(s) from fixture
head(s) to ground wire
from power supply and
secure with wire nut.
Carefully tuck wires into
upper post section before
attaching fixture head
to post.
b.
Attach fixture head to
post by threading fixture
head into upper post
section as shown.
continued
Break
Lower
Knuckle
Post
Section
Post
Base
Upper
Lower
Supply
Post
Post
Wire
Section
Section
Post
Base
1
2
Black
Wires
3
Diagram shown with
Multiple Fixture Heads
Mounting Post:
a.
Remove cap nuts from base, remove base and discard
plastic bag. Reattach base.
b.
For both single head fixtures
and multiple head fixtures,
thread post into base.
c.
Check post with level to
make sure that it is vertical.
If necessary, adjustments
can be made by
adjusting the
height of the hex
nuts on the anchor bolts.
Bulb Installation & Roof Assembly
a. For two screw and multiple screw assembly roofs, remove assembly
screws on roof (or underneath roof) and insert bulb(s). Reattach roof.
(see figure 1 and 2).
b. For harp assembly roofs, unscrew top finial to remove font assembly and
roof from threaded nipple. Insert bulbs. Reattach roof, font assembly and top
finial (see figure 3).
c. For fixtures with a hinged door, simply lift latch to open door. Insert bulb(s)
and secure door closed
with latch (see figure 4).
d. For globe assembly, install
bulb(s) first. Twist globe into
place and secure with fitter
screws, being careful not to
over-tighten as excess pressure
may cause globe to break
(see figure 5).
e. Turn power on.
Fixture
Head
Ground
Wires
Threaded
Nipple
White
Wires
Upper
Post
Section
Assembly
Screws
Figure 1
Two Screw Assembly
Top Finial
Font
Assembly
Roof
Cap Nuts
Figure 3
Figure 4
Harp Assembly
Hinged Door Assembly
Level
Cap
Nuts
Font
Assembly
Roof
Assembly
Screws
Roof
Figure 2
Multiple Screw Assembly
Globe
Latch
Set
Screws
Crossbar
Figure 5
Globe Assembly
Publicité
