HumanTechnik CM-1 Mode D'emploi page 38

Enjoying music or TV programmes
There is an audio input jack on the CM-1 transmitter which you can connect directly to
your television or music system using the supplied audio cable.
How to connect a device:
1. Switch off the CM-1 transmitter and the CM-1 receiver.
2. Set the volume control on the CM-1 receiver to a low value.
3. Insert the two cinch plugs (Ø 3.5mm) into the audio input jack of the CM-1 trans-
mitter.
4. Insert the other two cinch plugs into the audio output jack of your television or music
system.
5. Switch the CM-1 transmitter and the CM-1 receiver back on.
6. Adjust the transmission volume to a comfortable level.
Changing the transmission frequency
If you experience transmission interference, this may be due to the fact that there are
two CM-1 systems being operated in close proximity to one another.
The CM-1 transmitter and CM-1 receiver are capable of communicating in three different
frequency ranges. The frequency ranges are characterized by the letters "A", "B" and "C"
and apply to transmitters and receivers alike.
!
1. Switch off the CM-1 transmitter and the CM-1 receiver.
2. Open the battery compartment on your CM-1 receiver and take out the battery.
3. Use the supplied pin to adjust the frequency selector switch inside the battery
compartment.
4. Re-insert the battery and place the cover on the battery compartment.
5. Turn the CM-1 transmitter around so that it is facing away from you.
6. Use the supplied pin to adjust the frequency selector switch on the back of the
CM-1 transmitter to the same value that you had previously selected for your
CM-1 receiver.
7. Switch the CM-1 transmitter and the CM-1 receiver back on.
38 English
Bear in mind at all times that the CM-1 transmitter and the CM-1
receiver have to be set to the same frequency ranges. Discrepancy in
frequency ranges will prevent any transmission.