HumanTechnik CM-1 Mode D'emploi page 28

Inserting the battery into the CM-1 receiver:
The device runs on a rechargeable "AAA"-type battery. It can also run on a non-
rechargeable battery.
Where necessary, only use original replacement batteries.
If you run your CM-1 communication system on disposable batteries, don't place the
receiver onto the CM charger.
Ensure that the battery is placed the right way around into the battery
compartment. The stipulated installation direction is indicated on the bot-
tom of the battery compartment.
N.B. This battery is not adequately charged upon delivery and has to be
!
charged fully on the CM charger first of all.
1. Switch off your CM1 receiver.
2. Remove the battery compartment cover from your CM-1 receiver.
3. Place the supplied battery into the battery compartment (note the polarity!).
4. Place the cover onto the battery compartment.
5. Place the CM-1 receiver into one of the CM chargers.
The green LED on the CM charger flashes throughout the charging process.
The battery is fully charged after 12 hours.
28 English