HumanTechnik CM-1 Mode D'emploi page 27

Inserting the teleloop into the CM-1 receiver:
The CM-1 receiver can be used in two ways:
•
via the teleloop which is supplied
•
via a headset (not included in the scope of delivery)
In order to ensure successful transmission via a teleloop, your hearing aid must have an
integrated telecoil (T-coil) with which the sound information is transmitted inductively to
your hearing aid. Hearing aids generally tend to have a small T/MT switch which can be
used to set your hearing aid to inductive reception.
1. Insert the two plugs fully into the jacks on the top of the device. The marking on the
side of the plugs points towards the headset jack.
2. Turn the plugs through 90° so that the markings on the side point towards the top of
the device.
Teleloop (wound up)
Headset
English 27