Ibiza Light LAS-S130RG-BAT Manuel D'utilisation page 32

SAFETY RECOMMENDATIONS
•
INSTALL THE UNIT IN SUCH A WAY THAT NOBODY CAN STARE
INTO THE LASER BEAM.
• Before any installation and repair, please do cut off the power supply.
• For safety reasons, install the unit firmly to avoid injury and damage.
• Do not cover the unit.
•
Do not touch the unit with wet hands or pull the power wire forcefully.
• Please don't connect the power supply or turn on the system before
installation.
• Before switching on power, please make sure the mains lead is in good
condition.
• Where the MAINS plug or an appliance coupler is used as the
disconnect device, the disconnect device shall remain readily
operable.
• The system should be kept dry .Please don't use the system in the
condition of rain, wet or dust. For indoor use only.
• Do not turn on or off the system frequently.
• The lens shall be changed by a technician if it has become visibly
damaged to such an extent that its effectiveness is impaired, for
example by cracks or deep scratches.
• Do not let it work continuously for an extended period of time. Turn off
the system for 25 minutes after running continuously for 3 hours.
• Fixed Installation prevents the system from strong shaking or striking.
• Prevent objects to get into the system, or there will be malfunction.
• Leave at least 1m distance between the unit and other objects.
• When transport the system again, please use the original package to
avoid shaking.
• The user should comply with the instructions and warnings above. Any
damage, which is caused by incorrect operation or not following the
manual, is not covered by the warranty.
• Be sure that there are no inflammable or explosive objects within 1.5m
distance.
• Before installation, please make sure the power voltage matches the
system rated voltage.
• Be sure that the fan and exhaust is not blocked.
IMPORTANT
The laser is sensitive to low temperatures. Please operate the laser
at a room temperature of at least 18°C. If the laser is cold, let it heat
up for a while otherwise it might not work.
Operation
Plug the supplied mains adaptor into the DC socket and wait until the
built-in Lithium battery is fully charged. When the battery is empty, the
© Copyright LOTRONIC 2015 LAS-S130RG-BAT 3