Assembly Preparation; Assembly Instructions; Expanding The Cart Base; Mounting The Wheels To The Legs - Pit Boss PB340TGW1 Instructions D'assemblage Et D'utilisation

Parts are located throughout the shipping carton, including underneath the grill. Inspect the grill, parts, and hardware blister pack after removing
from the protective shipping carton. Discard all packaging materials from inside and outside of the grill before assembly, then review and inspect
all parts by referencing the parts list. If any part is missing or damaged, do not attempt to assemble. Shipping damage is not covered under
warranty. Contact your dealer or Pit Boss® Customer Service for parts: Monday through Sunday, 4am - 8pm PST (EN/FR/ES).
service@pitboss-grills.com | Toll-Free: 1-877-303-3134 | Toll-Free Fax: 1-877-303-3135
IMPORTANT: To ease installation, using two people is helpful (but not necessary) when assembling this unit.
IMPORTANT: It is advised to read each step entirely before starting assembly on instructions. Do not tighten screws completely
until all screws for that step have been installed. Hardware combination involving a locking washer and washer should be
installed with the locking washer closest to the head of the screw.

1. EXPANDING THE CART BASE

Parts Required:
1 x Main Barrel (#13)
Installation:
• Place a piece of cardboard on the floor to prevent scratching the unit. Lay
the main barrel on its back on the cardboard, lid facing upward. Open the
right side of the cart first by pressing down firmly on the right folding bar
(A), then swing open the right side cart legs. Once the legs are extended, the
right folding bar will spring back into the locked position. Ensure the diagonal
support bar extends completely and locks into a brace position, then tighten
the two folding bar knobs. Note illustration 1A.
• Next, open the left side of the cart by press down firmly on the left folding bar
(to unlock) and pull out the left side cart legs until extended. Once open, the left
folding bar will spring back into the locked position. Note illustration 1B.
IMPORTANT: The folding bar on each pair of cart legs should always be in a
locking position (raised up) when the grill is in use.

2. MOUNTING THE WHEELS TO THE LEGS

Parts Required:
2 x Wheel (#12)
2 x Wheel Cotter Pin (#D)
2 x Wheel Washer (#E)
2 x Wheel Axle Pin (#F)
Installation:
• Attach the wheel to the leg by inserting the wheel axle pin through the wheel,
then the leg hole, wheel washer, and finally secure using the wheel cotter
pin. Note illustration for order. Repeat installation for the other wheel. Once
installed, from the rear of the grill, lift the grill into an upright position.

ASSEMBLY PREPARATION

Tools required for assembly: screwdriver and level. Tools not included.

ASSEMBLY INSTRUCTIONS

1A
B
1B
2
A
C
7