VOLTCRAFT 1839924 Notice D'emploi page 31

• Confirm the 'Length' row with SET button (7). The length indicator is highlighted.
• Press the (1) or
• Confirm with the TEST OK button (3) to start the measurement on the cable at the same
time. The measured VOP value is displayed.
To save the measured result, proceed as follows:
• Press the (1) or
• Enter a name for the dataset in the 'Name:' row. To select alphanumeric characters for name
entry, press the
- (1) selects the figures 0 to 9 in a loop.
- (8) switches the alphabet letter loop.
• As soon as you have a set a character in the name, confirm the selection with the SET
button (7).
• To delete a character before the cursor, press the toggle button
The cursor jumps back one step. Press repeatedly to select additional characters to delete.
• You can enter up to 6 characters for the name. Close entry by confirming with the TEST
OK button (3).
• Use the (1) or
The row is highlighted.
• Briefly press the SET button (7) to confirm. Use the
or 'Coaxial' cable type and confirm the selection with the TEST OK button (3).
• Select the 'Producer:' row by pressing the
in the same way as outlined above.
• Select the 'Impedance:' row with the
button (7). Use the
75 or 100 Ohm) and confirm with the TEST OK button (3).
• Set the manufacturer data in the same way as outlined above.
• Under 'Velocity of Propagation' in the function menu, select the 'VOP
TEST' sub-menu item (see section 'd) Selecting the function menu
and functions'). The VOP measuring interface appears on the LC
display (4).
(8) button to set the known/measured cable length.
(8) button to select the name row and confirm with the SET button (7).
(1) or (8) button.
(8) button to enter the 'Type:' row to select the cable type for the dataset.
(1) or (8) button to select one of the possible impedance values (51,
(1) or
(1) or (8) button. Set the manufacturer data
(1) or (8) button and confirm with the SET
(coax/network) cable (2).
(8) button to select the 'Data'
31