Guided Tour - Sr55 Rear Panel - Samson Stage 55 Mode D'emploi

Guided Tour - SR55 Rear Panel

2 4
3
1
1: DC input - Connect the supplied 12 volt, 250 mA power adapter here, using the strain relief as
shown in the illustration below. WARNING: The substitution of any other kind of power adapter
can cause severe damage to the SR55 and will void your warranty.
-
Using the strain relief: Gather up a loop of wire and pass it through the strain relief,
then pass the adapter plug through the loop in order to create a knot.
2: Balanced output* - Use this electronically balanced low impedance (600 Ohm) XLR jack when
connecting the SR55 to professional (+4) audio equipment. Pin wiring is as follows: Pin 1 ground
(shield), Pin 2 high (hot), and Pin 3 low (cold).
3: Audio Output Level switch - Sets the audio output level attenuation of the balanced output
(see #4 below) to -20 dBm (line level) or -40 dBm (mic level). See the "Setting Up and Using Your
Stage 55 Series / Stage 5 Series System" section on page 12 in this manual for more information.
4: Unbalanced output* - Use this unbalanced high impedance (5K Ohm) 1/4" jack when con-
necting the SR55 to consumer (-10) audio equipment. Wiring is as follows: tip hot, sleeve ground.
4