Dyna-Glo DGY784BDP Mode D'emploi page 11

ASSEMBLY INSTRUCTIONS
5. Attach the lifting handles.
Insert 4 screws (AA) through the mounting
holes on one of the lifting handles (J) and
into holes on right side of smoker body (I).
Use a Phillips screwdriver to secure the
handles to the smoker body. Repeat on left
side.
Hardware Used
AA
M6x12 Screw
6. Attach the side dampers.
Dampers (K) are installed from the inside of
smoker body (I). Thread the damper handle
through the back hole of the side damper slots.
Align the damper (K) with the mounting holes
and insert 4 screws (BB) from the outside of the
smoker body (I). Secure each bolt with nut (DD)
from the inside of the smoker body (I). Use a
Phillips screwdriver and wrench to tighten the
nuts and bolts. Do not over-tighten. Damper
must be able to slide easily from side-to-side.
Hardware Used
M6x12
BB
Shoulder Screw
DD M6 Nut
5
x8
6
x8
x8
11
I
J
I
DD
K
BB