Publicité
CONTROL PANEL
⑱ Main switch 0/I
⑲ Soft wash (SOFT)
⑳ Medium wash (MEDIUM).
㉑ Hard wash (HARD).
Lights:
㉒ Child safety (orange).
㉓ Green LED.
㉔ Yellow LED.
㉕ Red LED.
㉖ Maintenance.
㉗ Power indicators ( SOFT,
㉘ Overheating.
Start-up
See the "INSTRUCTION MANUAL - SAFETY WARNINGS"
provided.
Start-up
⑱
(model- type: DIGIT)
- Insert the plug in the power outlet, the 0/I button
⑱ becomes blue.
- Press the gun lever until water comes out.
- Press the blue 0/I button ⑱ which becomes red.
Washing programs
⑲ ⑳ ㉑
- Each time the 0/I button ⑱is turned on, the
machine starts with the SOFT wash program ⑲.
- To change the program, press MEDIUM ⑳ or
HARD ㉑.
Green rectangular light
㉓
- The machine is on and working.
Yellow rectangular light
㉔
- The machine is in stand-by. To reactivate it, simply
press the gun lever.
Fixed red rectangular light
㉕
- Safety function. The electrical power supply is
deactivated because the machine has not been
used for more than 15 minutes (prolonged stand-
by). To turn the motor back on,
press the 0/I button ⑱ twice.
Flashing red rectangular light
㉕
MEDIUM,
HARD).
- Safety function. The electrical power supply
to the motor is deactivated because of leaks in
the hydraulic circuit. To turn the motor back on,
press the 0/I button ⑱ twice. See the paragraph
"TROUBLESHOOTING".
Child safety
㉒
- Press SOFT ⑲ and HARD ㉑ at the same time
for ⑳ seconds, until the Child safety symbol ㉒
flashes.
- The water jet does not come out even if the gun
lever is pressed; the buttons are locked too.
- To unlock the machine, repeat the operation.
Ordinary maintenance
㉖
The light ㉖ turns on after at least 10 hours
of operation. See the paragraph "Care and
Maintenance."
- Clean the filter in the water connection.
- Cleaning of nozzle. Use a small paper clip to free
foreign material clogging
or restricting spray tip.
- O-Ring Maintenance. The use of lubricant
(petroleum or synthetic grease) helps seat o-rings
providing an improved seal. Apply lubricant to
o-rings prior to assembling high pressure hose
(pump end) , high pressure hose (gun end) ,
garden hose to the pump , and plastic wand (gun
end). Purchase an O-Ring Maintenance Kit by
contacting
- Remove all debris, especially from the ventilation
slots.
- Check high-pressure hose.
- Check the power cable and plug.
- To turn the light off, press SOFT ⑲ and MEDIUM
⑳ at the same time for 5 seconds.
Overheating
㉘
- The light ㉘ turns on when the temperature inside
the machine exceeds the preset threshold. It does
NOT indicate a technical problem.
- Move the machine to a ventilated place and/or let
it cool down.
- Turn off the machine by pressing the 0/I button ⑱
and disconnect the plug from the power outlet.
15
Publicité
