Environmentally Safe Battery Disposal; Installation; Unpack The Machine - GreenWorks PH40B210 Manuel D'utilisation

EN
6 ENVIRONMENTALLY SAFE
BATTERY DISPOSAL
The toxic and corrosive materials below are in the batteries
used in this machine: Lithium-Ion, a toxic material.
Discard all toxic materials in a specified manner to prevent
contamination of the environment. Before discarding
damaged or worn out Li-ion battery, contact your local
waste disposal agency, or the local Environmental
Protection Agency for information and specific instructions.
Take the batteries to a local recycling and/or disposal center,
certified for lithium-ion disposal.
If the battery pack cracks or breaks, with or without leaks,
do not recharge it and do not use. Discard it and replace
with a new battery pack. DO NOT TRY TO REPAIR IT! To
prevent injury and risk of fire, explosion, or electric shock,
and to avoid damage to the environment:
• Cover the terminals of the battery with heavy-duty
adhesive tape.
• DO NOT try to remove or destroy any of the battery
pack components.
• DO NOT try to open the battery pack.
• If a leak develops, the released electrolytes are
corrosive and toxic. DO NOT get the solution in the
eyes or on skin, and do not swallow it.
• DO NOT put these batteries in your regular household
trash.
• DO NOT incinerate.
• DO NOT put them where they will become part of any
waste landfill or municipal solid waste stream.
• Take them to a certified recycling or disposal center.
7

INSTALLATION

7.1

UNPACK THE MACHINE

It is not necessary to assemble the machine.
WARNING
WARNING
WARNING
English
• If the parts have damage, do not use the machine.
• If you do not have all the parts, do not operate the
machine.
• If the parts are damaged or missing, speak to the service
center.
1. Open the package.
2. Read the documentation in the box.
3. Remove the machine from the box.
4. Discard the box and package in compliance with local
regulations.
7.1.1 FIT THE HEDGE TRIMMER HEAD
The hedge trimmer head can be mounted directly into handle
pole so as to achieve the standard length.
1. Insert the rear handle into the hedge trimmer head.
2. Slide the coupler and turn it until it is completely
tightened.
Periodically check the connections to ensure that they are
tightened securely.
7.1.2 REMOVE THE HEDGE TRIMMER
HEAD
1. Rest the machine on the ground.
2. Loosen the coupler.
3. Take off the hedge trimmer head.
6
WARNING
WARNING