Description - Festo 571813 Notice D'utilisation

EduTrainer 24 V power supply unit

7 Description

The power supply unit is suitable for all experiments involving electrical engineering/electronic components
as well as supplying power to other components with a nominal voltage of 24 V DC.
The electrical connection is established via 4 mm safety sockets. The unit is switched on and off by means of
the illuminated double-pole mains switch.
An LED is used to indicate that the DC output is ready for use. The DC output is protected against short-
circuiting and overloading.
Output voltage is electrically isolated. Output voltage can be connected to ground potential by means of an
external connection between the 0 V terminal and the protective grounding terminal.
The unit has a resettable 4 A fuse. This trips in the event of an overload and can be reset by the user after a
short cool-down time (20 s).
CAUTION
Do not wire multiple power supply units in parallel.
35
© Festo Didactic 8049693