Samsung DSR9500 Consignes D'utilisation page 31

OPERATING THE RECEIVER
1.2.2 Installer Mode
After checking the positioner's state, installer should use
this menu. He should set the "Disable Limits" before
using User mode.
Select the Drive Motor West/East and use the
keys to drive motor.
key drives to west and key drives to east.
Select "Enable Limit", in order to enable "Set Limit".
Select "Disable Limit", in order to disable "Set Limit".
Select "Reset Positioner" and key to reset positioner.
1.3 Solarsat Setting
This menu is only for the Solarsat antenna.
When you press this menu, you will get this message, "This menu is only for the
Solarsat antenna. If you have one-press OK, otherwise-press EXIT."
You can set the value according to your location.
To set the Value of Date and Time, use the
keys to change the value.
Use the / keys to change position.
Use the / keys to move each filed.
/
/
GB-18
D I G I T A L S
1.4 Auto Scanning
The sub menu "Auto Scanning" will enable download of off-air channels automatically
from the preprogrammed satellites.
To download channels automatically:
You can select All/Off/Only Free option mode in
each satellite.
Off : No Scan
All : Scan all the channels
Only Free : Scan free channels
Press key.
Auto Scanning menu will be displayed.
All the channels in the list from the selected satellite will be
automatically downloaded.
After scanning you will see "Your digital receiver found..." .
Afterwards you return to Auto Scanning menu.
1.5 Manual Scanning
To tune-in new channels and weak signals, the DSR9500 has been provided with
the option "Manual Scanning" where the channel data can be entered by the user.
After selecting the "5. Manual Scanning" from the Installation Menu, the following
screen will be displayed:
Select the target satellite for manual search.
Load a transponder.
This option will enable the user to load any
transponder from the preprogrammed list
available within the receiver.
N N o o t t e e : When you enter Frequency after setting
Load TR to New, the entered information
must include at least one channel to make
channel save possible.
Input the frequency of the transponder
you want to find.
Input the symbol rate of the transponder
you want to find.
A T E L L I T E R E C E I V
OPERATING THE RECEIVER
GB-19
E R