Olimpia splendid Unico Boiler Instructions Pour L'installation, L'emploi Et L'entretien page 52

3
3.3.11 Night well-being key
Press the T3 button
- Gradual increase of the set cooling temperature.
- Gradual decrease of the temperature set for heating (only HP models).
In order to activate the Night well-being key press button T3 press after having selected the required operating mode
through button T4 and having set the required temperature through button T7.
Ideally, you should start night well-being mode operation just before you fall asleep.
speed settings do not change any longer.
The '
The
again.
At this stage the temperature and fan speed settings made prior to starting Night well-being mode operation go back into effect.
3.3.12 Setting the operating programs
The air conditioner logic provides the user with a choice of two operating programs that can be set to start and stop at programmed
start.
3.3.13 Setting the exact time
Proceed as follows to set the exact time:
a) Press button T6
b) Press the toggle button T7 to increase or decrease the displayed hour until it matches the exact time.
c) Press button T6 again to display the minutes indication M D10.
d) Press the toggle button T7 to increase or decrease the displayed minutes until it shows the exact time in minutes.
3.3.14 Setting the times of the 1st and 2nd the operating programs (PROGR. 1 and PROGR. 2)
a) Press button T6
program).
b) Press the toggle button T7 to increase or decrease the display of the time when you want program 1 to start.
Every time you press one end of the toggle button the time increases or decreases by 30 minutes.
c) Press button T6
d) Press the toggle button T7 to increase or decrease the indication of the time when you want program 1 to stop. Every time
you press one end of the toggle button the time increases or decreases by 30 minutes.
e) Press button T6
f) Press the toggle button T7 to increase or decrease the display of the time when you want program 2 to start.
Every time you press one end of the toggle button the time setting increases or decreases by 30 minutes.
g) Press button T6
h) Press the toggle button T7 to increase or decrease the indication of the time when you want program 2 to stop. Every time
you press one end of the toggle button the time increases or decreases by 30 minutes.
i) To return to the routine operating mode just press the button T6 as many times as necessary to clear the relevant indications
from the display.
3.3.15 Starting and stopping the operating programs
Either or both of the programs can be used.
Use of Program no. 1 only.
Use of Program no. 2 only.
Use of Programs 1 and 2.
Disuse of both programs.
3.3.16 Reset all remote control functions
Press the button T10 to reset all the remote control settings.
By doing so all of the settings of the timer are cancelled and the remote control restores all of the default settings.
check the integrity of the display itself.
3.3.17 Managing the unit if the remote control is not available
UNICO BOILER MASTER
pressing the micro switch positioned underneath the hole located on the console by means of a pointy object.
52
may be disabled at any time (ideally when you wake up in the morning) by pressing button T3
once again to display the indication
once again to display the indication
once again to display the indication
H D10.
1
(Time to start the 1st
1
(Time to stop the 1st program).
2
(Time to start the 2nd program).
2
(Time to stop the 2nd program).