Olimpia splendid Unico Boiler Instructions Pour L'installation, L'emploi Et L'entretien page 51

In case of prolonged stop of the machine, it must be deactivated turning the main switch off or unplugging the machine
from the mains.
3.3.4 Well-being key (automatic operating)
3.3.5 Cooling
Activate this mode by pressing button T4
operating mode the compressor will start and the appliance starts emitting cold air.
Activate this mode by pressing button T4
are displayed. In this operating mode it is normal for the air conditioner to function intermittently.
3.3.7 Ventilation only
When used in this mode the air conditioner does not perform any action with regard to temperature and air humidity in the room.
Activate this mode by pressing button T4
At this stage you can select the fan speed (see paragraph 3.3.10).
WARNING: air emission is temporarily suspended while hot water is being produced.
3.3.8 Heating
When used in this mode the air conditioner heats the room. This function is only available on models with a heating pump (HP).
Activate this mode by pressing button T4
start and the air conditioner starts heating the room. The start of the compressor can be checked through the lighting of the relevant
green LED located on the console.
WARNING: the emission of hot air may be temporarily suspended in order for hot water to be produced only in the case
of a UNICO BOILER WALL with the Turbo1 and/or Turbo2 function enabled (Fig. 43).
3.3.10 Checking fan speed
Automatic.
until the droplet symbol D4 and automatic ventilation symbol D1
until the fan symbol D1 is displayed.
until the sun symbol D2 is displayed.
3
51
UNICO BOILER