Publicité
Les langues disponibles
Les langues disponibles
4.2
Slide the hinge guides (B1 & B2) onto the rear
frame stiles. The brackets should be positioned
outwards, with the double holed half uppermost (see
diagram).
4.3
Slide all the way up to the factory–fitted
permanent top stops.
4.4
Do not replace the plastic end tips at this
stage (see later at step 6.5).
Additional Top Stops
Depending on the floor to loft floor height (see bottom
of page 1), you may need to fit the additional top
stops provided (C2) (see table below).
5.1
Locate the additional top stops over the holes
approx 150mm (6") below the permanent top stops on
the rear frame of the ladder (see diagram).
5.2
Ensure the hinge guides (B1 & B2) are already
in place and below the additional top stops when
fitted.
Millimetres
2133 to 2286
2286 to 2415
2415 to 2565
2565 to 2705
2705 to 2845
2845 to 3000
Fitting Bottom Stops
6.1
Both end tips should now have been removed
from the rear frame at previous step 4.1.
6.2
Slide the bottom stops (D1) onto the rear frame
stiles.
6.3
Position the bottom stops 150 mm from the end
of the stiles (see diagram).
6.4
Fix with screws (D2).
6.5
Replace the plastic end tips removed previously
and secure with studs.
5.3
and nuts supplied (C1 & C3).
3 Section Operating Heights
Feet & Inches
'
'
7' 0" to 7' 6"
'
'
7' 6" to 7' 11"
'
'
7' 11" to 8' 5"
'
'
1
/
8' 5" to 8' 10
"
2
'
'
1
/
8' 10
" to 9' 4"
2
'
'
9' 4" to 9' 10"
B2
Permanent top stop
Fix the additional top stops using two M4 bolts
Notes
Fit additional top stops
Do not fit additional top stops
Fit additional top stops
Do not fit additional top stops
Fit additional top stops
Do not fit additional top stops
D2
D1
B1
C1
C2
C3
150 mm
07
Publicité
