Publicité
Les langues disponibles
Les langues disponibles
Connections
1.
Power supply input: Attach the IEC mains cable here. Built-in fuse
2.
DMX input: 3-pin XLR connector for DMX512 signal input
3.
DMX output: 3-pin XLR connector for DMX512 signal output
4.
LED display: Display of the functions and menu buttons to control the operating mode
5.
MENU buttons: See below for operation
6.
Mic: Built-in microphone for sound controlled operation
7.
PAR can mounts: Attach the PAR cans to the controller bar at the 2 points shown
8.
PAR & Laser connections: Connect the PAR & laser at the 2 points shown
9.
Light stand socket: Tighten the screw to secure the controller bar to the light stand
10.
Laser mounts: Fasten the Laser units to the controller bar at the 2 points shown.
MENU BUTTONS
You can set the operating mode of the unit via the 4 function buttons on the controller bar. Press the MENU
button to display the different functions (see table below for a detailed description of the functions). Use the UP
and DOWN arrow buttons to make your selection. Once you have chosen your desired function, press the ENTER
button to confirm the change.
Menu Map
AutP: PAR auto
operation
AutF: Laser auto
Auto
↔
operation
AutN: Light set
auto operation
SouP: PAR sound
activated
SouF: Laser Sound
Sou
↔
activated
SouN: Light set
sound activated
COL
↔
COLO
Manual - DJLIGHT65
AP01-AP13: PAR light
↔
effect
AF01-AF07: Laser
↔
effects
AN01-An10: Light
↔
effects
↔
SP01-SP13: PAR light effect
↔
SF01-SF07: Laser light effect
↔
SN01-SN10: Light set sound activated
R 0-255
G 0-255
B 0-255
↔
W 0-255
S00-32
N01-32
www.ibiza-light.com
↔
S01-S32: PAR light speed
S01-S32: Laser
↔
effect speed
S01-S32: Light
↔
set speed
Red
Green
Blue
White
Strobe
Motor speed
EN
N00-N09:
↔
Motor speed
N00-N09:
↔
Motor speed
3
Publicité
