Parkside PEBS 900 Mode D'emploi Et Instructions De Securite page 10

www.kompernass.com +++ www.kompernass.com +++ www.kompernass.com +++
For sanding large areas. For wood, plastic and metal
Please read carefully through the following information concerning safety and proper use. Before
reading, fold out the page with the illustrations and make yourself familiar with all the functions of
the equipment. Please read the operating instructions
advice carefully. Use the equipment only as described and for the indicated purposes. By doing
this you will be able to work in complete safety and produce better results. Be careful to keep these
advice notes and if necessary pass them on to a third party.
PROPER USE
The belt sander is intended for dry-sanding and polishing wood, metal and paint. Always use a
sanding belt and grade of grit suitable for the particular surface you are sanding. The speed selected
should also be appropriate for the material. Any other use or modification to the belt sander shall be
considered as improper use and could give rise to considerable dangers. The manufacturer will not
accept liability for loss or damage arising from improper use.
FEATURES OF THE PEBS 900
³
Auxiliary handle
·
Ventilation slots
»
Belt speed selector wheel
¿
Locking knob
´
ON / OFF switch
TECHNICAL INFORMATION
Rated consumption:
Nominal voltage:
Belt no load speed:
Belt /sanding speed
at maximum speed:
Abrasive surface:
Belt:
The PEBS 900 belt sander has full-wave electronics with additional control electronics, overload
control, soft start and power control.
Soft start with inrush current limiting.
PEBS 900 BELT SANDER
900 W
230 V ~ 50 Hz
n 650 rpm
0
350 m/min
75 x 150 mm
75 x 533 mm
t
10 10
below and the accompanying safety
²
Protective cover
¶
Dust extraction spout
º
Belt adjuster screw
¾
Tensioning lever
µ
Dust collection bag
Protection class:
Weight:
Sound pressure level:
Sound output level:
Vibration:
II/
3.8 kg
Lp = 87 dB (A)
Lw = 100 dB (pw)
< 2.5 m/s 2 (Hand-
arm vibration)