Steinbach Top Line Notice Originale page 18

Operation
Using the solar shower
Observe the following before using your solar shower:
- Bacteria can multiply in warm water if the product is not used for longer periods. Risk of infection!
The tank must be drained.
- The water temperature in the tank depends on the level of sunshine. In cloudy weather, the water
will take longer to heat up. The water can become very hot in the case of intense sunlight.
- Remove obstacles from the showering area.
To use your filled solar shower, proceed as follows:
1. Connect a garden hose to the hose adapter
garden hose so that no one can trip over it. Turn on the water supply faucet.
2. Turn the faucet to the center position (between hot and cold). Open the shower faucet.
2
3. Turn the faucet left or right to set your desired water temperature. Use the faucet to control the
water temperature and quantity, and enjoy showering in warm water.
4. After showering, close the shower faucet. Turn off the faucet of the water pipe.
The shower is finished.
Water is still coming out of the shower head even after the faucet has been closed. This
is caused by the water heating up in the unpressurized tank and is not a defect!
Cleaning
Only clean the product with a standard bathroom cleaner, clear tap water and a lint-free cloth.
Aggressive cleaning agents can damage the product. Dry the product with a lint-free cloth.
Disassembly
Draining the tank
Disconnect the solar shower from the water pipe. Open the faucet and unscrew the drain cap to drain
the water from the tank.
Dismantling the product
Remove the attachment screws from the base of the product while the second person supports the
product. Drain the remaining water from the tank and screw the drain cap into the tank.
Storage
After thorough cleaning and drying, store the product in a dry and frost-free place (= +5 °C).
Troubleshooting
Fault description
Water is still coming out of the
shower head even after the faucet
has been closed.
Water is leaking from a screw
connection.
18
and the faucet of the water pipe. Position the
3
Cause
This is caused by the water heating
up in the unpressurized tank.
The screw connection is not water-
tight.
Remedy
It is not a defect!
Wrap the thread in Teflon tape.