Midland NAUTICO 1 Manuel Du Propriétaire page 9

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Model NT1 Series
NAUTICO1 QUICK REFERENCE CHART
MENU
Channel
Press &
/
*
hold Menu
button
WX Channel
1~10
MONITOR
Pressing and holding the MONITOR button for 1 second will let you
hear noise so you can adjust the volume level of the radio when not
receiving a signal. This should be used to check activity on your
current channel before transmitting. Press and release the MONITOR
button for 1 second to get out of MONITOR mode.
SCAN
Your NAUTICO1 can scan all channels for activity. To enter, quickly
press the SCAN button. Repeat the same procedure to exit. Your radio
will rapidly scan each of the channels and stop on any active channel
for 5 seconds before resuming scan. When you press the PTT button
to transmit on an active channel, the scanning function will stop and
remain on the active channel. To resume scanning, quickly press the
/
button.
INSTANT CHANNEL 9/16
Channel 16 (Distress Channel) is used for calling other stations or
for distress alerting. You must monitor Channel 16 while standing by.
Channel 16 is only to be used in emergency situations. You can also
switch to Channel 9, the leisure-use call channel, without changing
your normal channel by pressing and holding the CH9/16 button for 1
second. Pressing the CH9/16 button again returns the radio to the
normal channel setting.
CALL TONE
Your NAUTICO1 can transmit a call tone for a fixed length of time. To
send a call tone, press the PTT button twice within 1/2 second. The
TX icon will appear while transmitting a call tone and a tone can be
heard on the speaker for confirmation.
Page 9
Keylock
Power
eVOX
oF/1/2
On/Off
Hi/Lo
*
WX Alert
depends on CHANNEL SELECTION
On/Off
Roger Beep
Call Tone
On/Off
1~3
www.midlandradio.com
®
CHANNEL SELECTION
INT/USA/CAN

Publicité

Chapitres

Table des Matières
loading

Table des Matières