Storch Turbo-Wash Traduction Des Instructions D'origine page 11

Assembly kit for Wamab
and ColorFree top
CAUTION:
1. The Turbo-Wash is only designed for a
maximum working pressure of 20 bar!
Any other use or operation of the TurboWash than descri-
bed in this manual is not permitted and may lead to mal-
function and accidents.
2. To be on the safe side, always turn off the water cock
of the water inlet after completion of the cleaning proce-
dures.
Cleaning paint rollers
1.
Before you guide the rollers into the Turbo-Wash, hold
the roller over the paint container and scrape off as much
of the paint as possible from the roller using a suitable
tool.
2.
Open the water cock of the water inlet.
3.
Open the cover of the Turbo-Wash, insert the scraped out
roller into the Turbo-Wash and close the cover again.
Warranty
A legal warranty period of twelve months from the date of purchase/date of invoice applies to our tools for commercial
customers.
Claims
If you wish to claim under our warranty or guarantee, please return the complete machine and your invoice to our logi-
stics centre in Berka, postage paid, or send it to one of our authorised service centres. We request that you contact us
beforehand by calling our free STORCH service hotline on 0800 7 86 72 47.
Warranty entitlement
Claims can only be accepted for material defects or manufacturing errors, and only assuming proper use of the appli-
ance. Wear parts are not covered by warranty claims. All claims shall become void in the event of installation of third
party components, improper handling and storage, as well as in the event of obvious disregard of the operating instruc-
tions.
Performing repairs
All repairs must be conducted on our premises or by an authorised STORCH service centre.
Disposal
End-of-life devices must not be disposed of as domestic waste. Please take them to a suitable collection point or hand
over the end-of-life device to your specialist dealer.
Installation on the
Wamab
Installation on the Color-
Free top
4.
Now open the ball valve of the Turbo-Wash completely as
far as it will go.
5.
Move the paint roller up and down a little in order to
achieve an equal cleaning. The best cleaning effect can be
achieved when the water runs out of the edge of the roller
and not in the middle so that the paint roller rotates at a
higher speed.
Then interrupt the water supply suddenly by shutting off
the ball valve on the Turbo-Wash. The paint roller conti-
nues to rotate at high speed and is immediately drier due
to the centrifugal effect. Open the cover, remove the rol-
ler from the Turbo-Wash and rinse the roller caps with the
rinser head if necessary. Now turn the roller bow 180°
and clean the roller again in the Turbo-Wash.
Replacement Parts
19 52 05 Nozzle distributor strip (without nozzles)
19 52 09 Sealing lips
19 52 13 Nozzle
11
View of assembly kit
wash basin side
Translation of the original instruction