CLEAN-UP AFTER INSTALLATION
When cleaning up after installation, use warm water and
an approved liquid cleanser to clean the surface.
CAUTION: Risk of product damage. Do not use
abrasive cleaners.
Stubborn stains, paint, or tar can be removed with
turpentine or paint thinner.
CAUTION: Risk of product damage. Do not
allow cleaners containing petroleum distillates to
remain in contact with module surfaces for any
length of time.
Plaster can be removed by scraping with a wood edge. Do
not use metal scrapers, wire brushes, or other metal tools.
Use warm water and an approved liquid cleanser to
provide mild abrasive action to remove residual plaster.
IMPORTANT CONSUMER INFORMATION
CLEANING ACRYLIC SURFACES
Do not use abrasive cleansers or solvents on acrylic
products.
Wipe out your acrylic fixture with a soft cloth after each use
to prevent a build-up of soap and scum. If the surface gets
excessively dirty you can use a general purpose cleaner
such as: Cinchr, Glass Plusr, 409r All Purpose, Dow
Soap Scum and Mildew Remover, Scrub Freer Mildew
Remover, Mr. Cleanr Lemon Fresh, or Fantastikr. You
can also use an automotive-type polishing compound,
followed by an application of good-quality paste wax.
Avoid cleaning products that contain the following
chemicals, as they will damage the finish of your acrylic
fixture: acetone, ethyl alcohol, amyl or ethyl acetate,
sodium hypochlorite, toluene, or phenol.
Extreme heat such as that generated by cigarettes or
portable heaters can damage acrylic surfaces; do not use
such items near your fixture.
CALL US FOR HELP
Here's what you need to do if you require service:
First review the installation instructions to ensure correct installation. For additional assistance in the USA, call our
Customer Service Department for direct help. You may also contact us at our web site listed below.
A
1011312-2-
Call 1-800-4-KOHLER within the U.S.
Call 001-877-680-1310 within Mexico
Call 1-800-964-5590 within Canada
www.kohler.com
6
Kohler Co., Kohler, WI U.S.A.