3- Pre-Installation Notes - Facnor HF700 Notice De Montage

3- PRE-INSTALLATION NOTES

3.1 GENERAL REMARKS WITH REGARD TO FACNOR FURLING SYSTEM:
 Simple to assemble: no mast unstepping, no section cutting, no drilling
The FACNOR headsail furling system is one of the easiest to install:
- it does not require unstepping the mast
- under most circumstances you will not need to cut any section on account of the
patented Facnor telescopic section.
- no drilling is necessary.
 Easy maintenance : rinsing
Facnor furling systems do not require any specific maintenance, however it is
recommanded to rinse the furling system several times each season.
3.2 ELECTRICAL DANGER AND MAST SUPPORT
DO NOT BRING YOUR FURLING SYSTEM IN CONTACT WITH ELECTRIC
CABLES OR HIGH TENSION LINES.
sections which are highly conductive. Contact by the system with power lines can be fatal.
DO NOT INSTALL YOUR REEFING SYSTEM WHEN STORMY WEATHER HAS
BEEN FORECAST. A lightening striking the mast can travel down the system. Death could
result from shocks induced from touching the reefing system.
MAKE SURE THE MAST IS SECURED BEFORE REMOVING THE BOTTOM
FIXING PIN OF THE FORESTAY.
in place. Kit components will be fed over the bottom of the forestay. Therefore, the bottom
fixing pin will have to be removed. Before operating, support the front mast with a Spinnaker
or Genoa halyard. DO NOT USE A SNAP SHACKLE OR SHACKLE HALYARD BUT LASH IT.
We recommend that you change your forestay if it is too old. You may contact one of our
dealers. For information about the nearest Facnor retailer, contact us at +33 (0)2 33 88 50 22 or visit
our web site : www.facnor.com
The services of a professional yacht rigger or sailmaker could end up saving you
time and should you improperly install the furler or encounter an unusual rigging
problem.
Enrouleurs hydrauliques FACNOR
The headsail reefing system is made from aluminium
Facnor reefing system can be assembled with the forestay
.
code /part No document: 29160050159 –
- rev 2018 - page 18/25