oneConcept TurboBuddy Mode D'emploi page 16

EN
16
CLEANING AND CARE
1. Remove the whole dust bin by pressing the release button and take the dust
container off. (pic1)
2. Pulling out the filters and emptying the contents of the dust container into a suitable
vessel or bag. The filter can be shaken clean or cleaned and rinsed using warm
water. Make sure that the parts are dry before they are re-installed. (pic2)
3. Empty the dust tank. (pic3)
4. Washing the filters under water. (pic4)
5. Re-install the components
Note: Make sure that the parts are dry before they are re-installed.
6. Put the filter into dust container.Assemble the dust bin to the motor unit following up
the opposite procedures for detaching the dust bin.