Leggett & Platt Premier premium MODELS Mode D'emploi page 18

h. Measure the center-to-center distance between the mounting slots of the
headboard bracket flanges (FIGURE 17).
i. If bracket flange adjustment is required to accept the headboard, remove the
1 inch long hex head bolts and move flanges side-to-side for the adjustment
(FIGURE 17). Reinstall bolts. Tighten all headboard mounting bolts.
j. Firmly tighten all bolts of both headboard bracket assemblies.
k. Install headboard.
FIGURE 17
REMOVE 1 INCH LONG HEX HEAD BOLTS AND RELOCATE
FLANGES TO ACHIEVE CENTER-TO-CENTER DISTANCE
REQUIRED FOR HEADBOARD MOUNTING HOLES
18
Premier Series Owners Manual 99301588-b
™
INSTALLATION
MEASURE FLANGE SLOTS
CENTER-TO-CENTER TO CHECK
HEADBOARD HOLE LOCATION