Craftmade UH52 Mode D'emploi page 4

5
1. Connect fan wires to ceiling wires: white fan wire to white outlet wire
and black to black. Wire connectors (S5) are provided for your
convenience. If an additional blue wire is present then also connect the
blue wire to the black wire. (Optional light kit may be wired to individual
wall switches, if desired.)
2. After connections are made, turn splices upward and push carefully
into outlet box. Separate blue and black wires on one side of the box, and
white wires on the other side.
There are 3 colored wires coming from the top of the motor.
NOTE: Wire connectors that are not pushed up into the outlet box may in time sag and
rub against the top of the motor housing. This sound can be mistaken for bearing noise.
"J" Hook (S9)
Ground
White (Neutral)
Black (Power)
Wire Connectors (S6)
Black
White
White
Black
UC2000
Step 5
Wire Connectors (S6)
White
Ground (Green)
Black
Blue
Blue
Wire Connnections
Outlet Box Fan wires
Black Black
(Hot wire for fan)
Green Green
(Ground wire)
White White
(Neutral wire)
Black Blue
(Light kit wire)
6
Attach fan motor/mounting bracket (2) to the mounting plate (1) using
the nuts for the mounting plate (S5).
Note: Tighten only until the nut and both are even.
Step 6
Mounting Plate (1)
Nuts for Mounting
Plate (S5)
Fan Motor/
Mounting Bracket (2)