Craftmade UH52 Mode D'emploi page 3

Preparation
Important: When using an existing outlet box, be sure the box is securely
attached to the building structure and can support the full weight of the fan.
Failure to do so can result in serious injury or death.
1
Step 1
Turn off circuit breakers and wall switch to the
fan supply line leads.
Warning: Failure to disconnect power supply prior to
installation may result in serious injury or death.To
reduce the risk of shock, this fan must be installed with
an isolating wall control/switch.
2
Check to make sure blades are at
least 30" from any obstruction.
Check downrod length to
ensure blades are at least
7' above the floor.
Step 2
84"
(2.1m)
Min.
3
Prior to securing mounting bracket, screw "J" hook (S9) into ceiling
outlet box as a secondary support means. Secure mounting plate (1)
using screws and washers (S2) directly to the outlet box. If not mounting
to an outlet box, use wood screws (S1) and mount securely to a beam or
joist.
NOTE: Do not mount directly to sheet rock or ceiling tile.
NOTE: J Hook installation is a Canadian requirement only.
"J" Hook (S9)
Ceiling
30"
0.75m
Min.
4
Hang the fan motor/mounting bracket (2) onto the hook that is
positioned on the mounting plate (1).
Mounting Plate (1)
Fan Motor Mounting Bracket (2)
Step 3
Support Beam
OUTLET BOX
Wood Screws
& Washers (S1)
Screws & Washers
for Mounting Plate (S2)
Step 4
Mounting Plate (1)