Niko 10-830 Mode D'emploi page 28

14 15 16 17 18 19 20 21 22 23 24 25
1 2 3 4 5
230V~
3.3. OPERATION AND USE
Relay 10-836 must be programmed by means of the service set (10-870). Programming manu-
ally is not possible. The relay can be programmed in 2 ways. If you program the serial number
of the relay on the bell push buttons of an external unit, several programmings are possible. If
you carry out programming on the relay itself, only one programming is possible.
28
10-830/10-835/10-836/10-837/10-840
a b R S P
6 7 8 9 10 11 12 13
fig.5: wiring diagram with Relay 2
a b P K1 K2
:BUS
relay
Take out jumper,
if using three-
wire system!
max.
2A,24V DC