Niko 10-830 Mode D'emploi page 25

Congratulations on your purchase of this product from the Niko Access Control range. Please
read the complete manual before attempting installation.
1. LEGAL WARNINGS
- Read the complete manual before attempting installation and activating the system.
- The installation has to be carried out by a qualified person and in compliance with the
statutory regulations.
- This user manual has to be handed over to the user. It has to be included in the electrical
installation file and has to be passed on to any new owners. Additional copies are available
on the Niko website or via the support service.
- During installation, the following has to be taken into account (not limited to list below):
- The statutory laws, standards and regulations;
- The state of the art technique at the moment of installation;
- This user manual, which must be read within the scope of each specific installation, only
states general regulations;
- The rules of proper workmanship
- In case of questions, you can consult Niko's support service or contact a registered control
organisation.
Support Belgium:
+32 3 760 14 82
website : http://www.niko.be
e-mail: support@niko.be
In case of a defect, you can return your product to a registered Niko wholesaler, together with
a clear description of your complaint (Conditions of use, stated defect...).
2. Relay 1 (10-835)
2.1. DESCRIPTION
Relay 1 is designed for flush mounting in an external unit (NOT of the Advance series) or a
Focus internal unit. This relay can o.a. be used to control a door lock.
2.2. INSTALLATION
fig.1: Relay 1
of the relay are connected to terminals P and R of a Niko Access Control external unit or to
10-830/10-835/10-836/10-837/10-840
Support Slovakia:
+421 263 825 155
e-mail: niko@niko.sk
This DC relay is designed for flush mounting in an external unit
of the Confidence, Balance, Evidence or Alliance series or in an
internal unit of the Focus series. If an installation is provided
with several external units and several locks must be controlled,
you can open the resp. doors by connecting one Relay 1 per
external unit.
If you connect a Relay 1 to a Focus internal unit, you can use the
first function key of this internal unit to switch Relay 1. The wires
25