Télécharger Imprimer la page

Uline S-17128 Mode D'emploi page 2

Publicité

Les langues disponibles

Les langues disponibles

WARNING! It is the responsibility of the user to
operate the pump in conformance with OSHA
rules for dispensing liquids. Failure to follow
all warnings and general safety information
can result in a fatality, personal injury and/or
property damage!
1.
Never pump flammable or explosive chemicals.
2. Never pump hot liquids.
WARNING! In order to properly use this product,
familiarize yourself with the pump and liquid to
be siphoned. Not suitable for all liquids.
1.
Prior to use read operating instructions
1. Close vent cap at top of pump.
NOTE: Pump will not siphon with cap not fully
tightened to handle.
2. Place suction tube in container from which liquid is
to be siphoned.
3. Place discharge tube in container into which liquid
is to be transferred.
4. Grip handle and operate bellows with up and down
motion until liquid flows continuously.
5. Liquid flow will be automatically maintained by
gravity through discharge tube when the liquid level
at discharge is lower then the liquid level in pail.
6. When siphon action stops or slows due to low liquid
level in drum, elevate the drum, or operate hand
grip to manually maintain flow. When discharging
PAGE 2 OF 6
SPECIFICATIONS
Flow rate per stroke
Inlet
Outlet
Bung Adapter
Suction Tube (Length & Material)
Packing Gland
Wetted Parts
Viscosity
Max. Temp.
GENERAL SAFETY
INSTALLATION
3/4" OD
3/4" OD
420 cps
3. Wear safety glasses at all times when working with
pumps.
4. Wear a face shield, proper apparel, and respiratory
protective equipment when pumping hazardous
chemicals as set forth in the United States OSHA
Safety Data Sheet.
5. Neutralize and/or clean up spills immediately.
6. Rinse thoroughly after use.
2. Determine the depth of the container in which
pump is to be inserted. If the length of suction tube
is greater than container depth, cut tube at a 30°
angle to fit container. Use caution when cutting tube.
OPERATION
thick liquids you may need to operate hand grip to
speed up discharge of liquid.
7. To stop liquid flow: open vent cap at top of pump.
8. To resume flow: Close cap, grip handle and operate
bellows with up and down motion until liquid flows
continuously.
9. When finished pumping, place discharge tube in
storage clip to prevent liquids from dripping.
10. If pump is removed from drum, rinse thoroughly in
liquid compatible with both the pump and fluid.
NOTE: For any questions about chemical
compatibility, contact your chemical supplier.
1-800-295-5510
uline.com
7 GPM
2" PE
34" PE
PE
PE
140°
0922 IS-17128

Publicité

loading