HURAKAN HKN-TOP3 Mode D'emploi page 9

⚫
To heat up the toaster, turn the temperature knob to the lowest temperature position. It
can take 10 to 15 minutes to heat up.
⚫
Once the toaster has heated up, turn the temperature knob to the desired position.
⚫
Bread coated with butter or another product (garlic bread, cheese sandwiches, etc.) must
not be toasted because the fat and oil settle on the inside of the toaster, form soot and
may cause a fire.
CLEANING
⚫
Before cleaning, the toaster must be switched off, disconnected from the mains and
cooled.
⚫
Do not use abrasives or cleaning agents.
⚫
Do not wash the appliance under running water or a water jet.
⚫
Clean with a soft, damp cloth and a small amount of cleaner.
⚫
During cleaning it is necessary to prevent water from entering the electrical connections
and control knobs.
OTHER SAFETY REQUIREMENTS
⚫
The toaster should be lifted with caution because it is very heavy.
⚫
The toaster's outer surfaces may become very hot when in operation.
⚫
Before reinstalling or moving the toaster, disconnect it from the mains and let it cool down.
⚫
Do not use the toaster after a failure or damage.
⚫
Do not disassemble the toaster or repair internal parts that are not intended for user
maintenance.
⚫
A damaged power cord may only be replaced by a qualified specialist.
⚫
The toaster must not be used by persons with reduced physical, sensory or mental
capabilities.
⚫
Do not immerse the toaster body, power cord or plug in water or any other liquid.
⚫
The toaster may only be used by persons who have been instructed in safety aspects.
⚫
Children must not use the toaster. If there are children nearby when the toaster is in
operation, special precautions should be taken to ensure that the children do not play with
it.
⚫
It is not permitted to take bread out of the toaster using improvised tools such as knives,
etc.
DEVICE MAINTENANCE
⚫
Before carrying out any maintenance work, the toaster must be switched off, disconnected
from the mains and cooled down.
⚫
Outer surfaces: to keep the surfaces shiny, it is recommended to wipe them daily with a
damp cloth. Persistent stains can be removed with a non-abrasive detergent or a special
cleaner for stainless steel. Hard to reach areas are cleaned with a small brush and a neutral
soap solution. The use of abrasives is not recommended, as they can cause scratches that
impair the appearance of the toaster and contribute to the rapid contamination of
surfaces.
EN
9