Asist AE5PO85 Mode D'emploi page 41

ADDITIONAL SAFETY INSTRUCTIONS
Please read these safety instructions carefully before
use and keep them in a safe place.
! - This symbol indicates the risk of injury or damage
to the device.
! Failure to follow the instructions in this manual may
result in injury.
! The multifunctional saw complies with the applicable
technical regulations and standards.
! When working with the saw, wear work gloves, a
safety helmet, safety goggles or a protective shield
and a dust mask.
! It is recommended to use hearing protection when
working indoors.
! When cutting, hold the saw firmly with both hands
and ensure a stable position of the whole body.
! Check the saw blade before starting work.
! Replace a blunt, cracked or otherwise damaged saw
blade with a new one.
! Do not use the saw to cut large workpieces whose
dimensions exceed the permissible values specified
in the technical parameters (especially when cutting
pipes).
! Otherwise, there is a risk of the saw blade breaking,
which can cause serious injury.
! When working at heights, always make sure that the
space below you is free and that there are no people
or animals in the immediate vicinity.
! When cutting blindly (for example in plasterboard
walls), always first check the course of gas, water or
electrical lines with a metal detector. Always hold the
tool only by the insulated parts.
! When cutting, make sure that the moving saw blade
does not hit any obstacles. Pay attention to the place
where the cut part of the material falls off. Cut parts
can cause injury.
! When cutting metals, sparks may fly out of the
product. Make sure that there are no people or flam-
mable, flammable objects in the vicinity of the flying
sparks. There is a risk of fire.
! Do not touch the saw blade or the product after
work, they can be very hot and cause burns.
! When removing the saw blade from the cut while the
tool is running, the saw blade may break or the saw
may be knocked out of the hands. Remove the saw
blade from the cutting slot after switching off the saw
and stopping the saw blade completely.
! When cutting metals, always use suitable coolants
(cutting oil or emulsion). When cutting metals dry,
there is a risk of premature wear of the saw blade.
! Do not start the saw with the saw blade inserted in
the workpiece.
! Never overload the saw enough to stop the engine.
! Never try to stop the movement of the saw blade,
even when the engine is already switched off.
! The saw blade will extend itself very quickly. The
teeth of the leaf are very sharp.
Never aim the saw at people.
- Use protective equipment against noise, dust and
vibration !!!
SAVE THESE SAFETY INSTRUCTIONS !!!
DESCRIPTION (A)
The saw is designed for straight cutting of wood,
plastics, metals or building materials. The saw has
a quick-release chuck, the handle can be rotated 90
degrees.
1. Handle
2. Power switch
3. Chuck
4 Cruise control
5. Lock button
6. Cutting blade / 3x /
7. Sliding support plate
8. Handle release button
9. Swivel handle
10. LED
Pictograms
Pictograms on the product packaging:
a) Power supply values
b) Power consumption
c) Idle speed
d) Max. depth of cut -met
e) Max. depth of cut - wood
f) Cut length
USE AND OPERATION
ASIST tools are intended for home or hobby use only.
The manufacturer and importer do not recommend
using this tool in extreme conditions and under high
loads.
Any additional requirements must be the subject of
an agreement between the manufacturer and the
customer.
Saw blade replacement
Follow these steps to remove or insert the saw.
1. Turn the quick-release chuck (11) to the side
and hold it in this position.
/ If necessary, you can remove the guide support
plate /
If a saw blade is inserted, remove the saw blade from
the quick-release chuck.
Insert the saw blade into the quick release. Make sure
the teeth are pointing down.
Push the saw blade into the quick release until it
41