JVD ZEPHYR II Notice Originale page 4

TECHNICAL CHARACTERISTICS
Supply voltage : 220-240V
Power : 2100W
Electrical insulation : Class II – no need earthing
Sound pressure level : 69 dBA
INSTALLATION
This appliance is designed to be used in commercial areas.
As the appliance is rated class II, it does not need earthing. Phase and neutral are connected without any
polarity on the internal connector.
The power wire must be at the back of the appliance and must be out of reach when the hand dryer is
screwed on the wall. The section of the wires has to be 2,5mm².
Never attempt to install the appliance yourself, unless you are a suitably qualified technician.
Doing so may affect its operation and safety.
Do not installed the appliance when it is connected.
Install the appliance on a support that is sufficiently solid to attach it securely.
Precautions before installing the appliance
Do not install the appliance in places with the following characteristics:

Temperature lower than –10° or higher than +40°C.

Places where the appliance may come into direct contact with water.

Places exposed to severe condensation.

Places where corrosive gases are present.
Information for installation

Use a monophase AC current of 220V-240V / 50 Hz.

Use a power supply cable with conductors with a cross-section of 2.5mm².

Avoid places where the appliance could be hit by a door.

Install the appliance on a perfectly flat wall.

Allow for the power supply cable inlet.

Find out the dimensions and space requirements of the product before installing.
Installation steps

Remove the cover

Insert the power wire in the hole and fix the appliance on the wall.

Connect the power supply to the connecting block (terminals identified by the arrows ).
You must use the drilling clamp supplied with the appliance.

Replace the cover and fix it with the two screws and the "allen" key supplied with the appliance.
USE
The appliance automatically starts when you put your hands under the unit.
ADJUSTMENT OF THE SENSITIVITY
The sensitivity of the appliance can be adjust with the potentiometer accessible thanks to the little hole
under the appliance. When you turn anticlockwise the hand dryer will be more sensitive. If you turn
clockwise the hand dryer will be less sensitive.
SERVICING AND CLEANING
The appliance must be cleaned and serviced only by suitably qualified persons and each 6 monthes
The outside can be cleaned with a soft, dry cloth.
If any parts show signs of abnormal wear, please contact After-Sales.
In case of accident, malfunctioning or blockage of the appliance, disconnect the appliance from
power supply but never attempt to repair the appliance yourself, unless you are a suitable qualified
technician.
GUARANTEE
Faulty connection or any damage resulting from wrongly usage or which is in contradiction to the
instructions in this leaflet will render the guarantee void.
50Hz
drilling clamp
4