Norcold N41X Manuel D'installation page 6

- If the design of the vehicle does not allow you to install the roof exhaust vent
directly above the condenser of the refrigerator:
- Align the roof exhaust vent [12] above the lower intake vent and move it
inboard as necessary (See Art01639).
- Install two baffles [13] to prevent stagnant hot air in the area [14] above
the refrigerator.
- Make sure both baffles are the full width of the inside of the enclosure.
- Make sure that both baffles are no more than 45° from vertical [20].
- Put one baffle between the top rear edge of the refrigerator and the
inside edge of the upper exhaust vent opening.
- Make sure there is less than 1/4 inch clearance [15] between the
baffle and the top of the refrigerator.
- Put the other baffle between the outside edge of the upper exhaust
vent opening and the side wall of the vehicle.
- If you install the upper side exhaust vent (See Art01637):
- For N41X models, make sure the distance [25] from the floor level to the top of
the rough opening for the upper exhaust vent is at least 41 3/4 inches or poor
cooling performance can occur.
- For N51X models, make sure the distance [25] from the floor level to the
top of the rough opening for the upper exhaust vent is at least 47 3/4
inches or poor cooling performance can occur.
- Align the upper exhaust vent [24] horizontally above the lower intake vent
[9] of the refrigerator.
- Install a baffle [13] to prevent stagnant hot air in the area [14] above the
refrigerator.
- Make sure there is less than 1/4 inch clearance [15] between the
baffle and the top of the refrigerator.
- Make sure the baffle is the full width of the inside of the
enclosure.
- If there is more than 1 inch of clearance between the rear of the refrigerator
and the enclosure, add two baffles [16] to the rear of the enclosure (See
Art01637, Art01638, and Art01639):
- Put one baffle at the top edge of the lower intake vent [9].
- Put the other baffle at the lower edge of the condenser [11] of the
refrigerator.
- Make sure the baffles are less than 1/4 inch from the coils [10] and
condenser of the refrigerator.
- Make sure the baffles are the full width of the inside of the enclosure.
- For N41X models, if the construction of the vehicle does not allow the distance [25] to be 41 3/4 inches, the distance (optional only)
can be as little as 36 inches (See Art01647) if you obey the instructions that follow:
Installation Manual 6
Art01639
Art01637
OR
13
14
13
24
14
16
12
20
13
15
16
9
10
15
25
9
10