NSK S-Max pico Mode D'emploi page 10

4. Replacing the Cartridge
1 ) Insert a dummy bur into the chuck.
2 ) Unscrew the Head Cap by turning counter-clockwise and remove.
3 ) Push up the dummy bur upwards to remove Cartridge.
4 ) Clean the interior of the Head casing.
5 ) Insert the new Cartridge.
6 ) Replace the Head Cap and firmly screw into place.
SX-PU03: Order Code P1140200
CAUTION
· Make sure that the O-Ring is removed, when removing the Cartridge. O-Ring might be remained in the Head, when removing the Cartridge. If
there is a remained O-Ring, the new Cartridge can not be inserted properly.
· Use only NSK genuine cartridge. If you use other cartridge, specification may not be satisfied and we can not warranty of this situation.
· The head cap screw thread is very fine. To prevent damage to the thread always first tighten the handpiece head cap using fingers, then
secure with the head cap wrench.
8
· Make sure that the O-ring (Fig. 6) is correctly located on the cartridge.
Head
PUSH
Cartridge Head Cap Wrench
O-Ring
Fig. 6