Technical Data; Disposal Of Packaging And Appliances - Atag WG3X Mode D'emploi Et Instructions D'installation

assembly
(continued)
motor module
Screw two screws (4.2 x 9.5) halfway into the rear holes (1)
in the motor module (see illustration).
2
3
Slide the motor module upwards in the mounting socket and
pull the motor module backward slightly so that it catches in
1
the mounting socket and remains suspended (2).
Fix the front two screws (4.2 x 9.5) as shown in the
illustration (3). Then tighten the rear two screws (2).
Make the necessary plug connections.
Fit the discharge duct.
lower telescopic pipe
2
Slide the lower telescopic pipe upwards over the motor
module (1).
Hold the pipe up by carefully pushing a pen or screwdriver
into the hole that has been made for this purpose in the front
of the motor housing (2).
1
fitting the hood
Fit the hood to the motor module. First hook the rear of the
4
hood into the motor module from underneath (1). Then push
the front upwards (2), so that the two bolts supplied (M5 x
1
2
3
12) can be screwed in (3). Level the hood using these bolts.
Make the plug connections in the hood.
Allow the lower telescopic pipe to drop (4) so that it slides
into the edge of the hood.
Put the filters in place and test the extractor hood.
GB 16

technical data

type number:
power supply:
connected load:
dimensions (h x w x d): see "fitting dimensions"
approvals mark:
This appliance complies with the CE directives.
external motors
NB: For appliances with an external motor, ATAG
recommends the use of the following types of external
motors:
WA111B5U WA300B5U
WA111C5U WA300C5U
ASVM0021 AS000387
ASVM0025 ASVM0023

disposal of packaging and appliances

The packaging of the appliance is recyclable. It can be
made up of:
– cardboard
– polyethylene
– CFC free polystyrene (PS rigid foam)
– polypropylene straps around the box
Please dispose of these materials in a responsible way in
accordance with the regulations of your local authority.
Your local authority will also be able to give you information
about disposing disused household appliances in a
responsible way.
see data plate in the hood
230 V - 50 Hz
see data plate
Kema
GB 17