ASROCK 939A8X-M Guide D'installation Rapide page 15

Les langues disponibles

2.6

2.6 Serial A

Serial A

Serial AT T T T T A (SA

Serial A

A (SA

A (SAT T T T T A) Hard Disks Installation

2.6

Serial A

A (SA

This motherboard supports Serial ATA (SATA) hard disks and RAID functions

(including RAID0, RAID1, and JBOB), but it doesn't support SATA hot-plug and

SATA RAID hot-swap. This section will guide you to install the SATA hard disks.

STEP 1: Install the SATA hard disks into the drive bays of your chassis.

STEP 2: Connect the SATA power cable to the SATA hard disk.

STEP 3: Connect one end of the SATA data cable to the motherboard's SATA

connector.

STEP 4: Connect the other end of the SATA data cable to the SATA hard disk.

1. If you plan to use RAID 0, RAID 1, or JBOD functions on SATA, SATA

HDDs must be operated in "RAID" mode.

2. "RAID" and "non-RAID" mode are options under "SATA Operation Mode" in

BIOS setup. Please refer to page 28 of User Manual in the support CD for

details. They need different drivers during actual operation.

ASRock 939A8X-M Motherboard

A) Hard Disks Installation

1 5