Hardware Contents; Preparation Before Assembly - Dyna-Glo DGU951SSE Mode D'emploi

HARDWARE CONTENTS (PRE-ASSEMBLED)
AA
M4 x 35 mm
Screw
Qty. 4
Note: Four M4 x 35 mm
screws (AA) are pre-
assembled in the door
handle (F).

PREPARATION BEFORE ASSEMBLY

Before beginning assembly of product, make sure all parts are present. Compare parts with
package contents list and hardware contents list. If any part is missing or damaged, do not
attempt to assemble the product. Please read and understand this entire manual before at-
tempting to assemble, operate or install the product. If you have any questions regarding the
product, call our customer service department at 1-877-447-4768, 8:00 a.m.- 4:30 p.m. CST,
Monday - Friday.
Estimated Assembly Time: 15 minutes
Tools Required for Assembly (not included): Phillips Screwdriver
BB
M6 x 12 mm
Screw
Qty. 6
Note: Four M6 x 12 mm screws
(BB) are pre-assembled on the
bottom of the smoker cabinet
assembly towards the front.
Two M6 x 12mm screws (BB)
are pre-installed on the front of
the smoker cabinet assembly
(A) towards the bottom.
CC
M5 x 12 mm
Screw
Qty. 12
Note: Eight M5 x 12 mm
screws (CC) are pre-
assembled on the bottom of
the smoker cabinet assembly
(A) towards the rear. Four
M5 x 12 mm screws (CC) are
pre-installed on the back of the
smoker cabinet assembly (A)
towards the top.
9