Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION
Mounting to Junction Box
1.
Push fixture wires through the threaded hole of the
junction box cover and screw stem in. Use lock nut to
firmly hold the fixture.
2.
Connect fixture wires to the transformer wires
(polarity not critical).
3.
Attach the fixture and cover with cover gasket
securely to the junction box.
To Adjust Fixture Aiming
Loosen set (B) with allen wrench (provided by others), aim fixture. Tighten the screw. (Figure 1.)
8-32 Screw
Hex Button(A)
Cambria 203 standard fixtures are shown (for Use with MR16 or LED Lamp). Similar standard fixtures are available for Cambria
201 and 201-DC (for Use with MR11 Lamp).
Figure 1.
Lamp Requirements
For 201: 12V, MR 11, 35 Watt max Bi-Pin halogen lamp.
For 201-DC: 12V, MR 11, 35 Watt max D.C. Bayonet Base
halogen lamp.
For 203 (Shown): 12V, MR 16, 50 Watt max Bi-Pin
halogen lamp. (Figure 2.)
For 203 (LED): 12V, 8 or 12 Watt max Bi-Pin LED module.
Check package and fixture labeling for proper lamp type
and wattage.
Cambria 203
Standard Fixture
Options
203
203-FM
Figure 2.
Hood
203-CRS Shown
1/2 NPS
203-FL
Installation Instructions - Cambria 201, 201-DC, 203
ADL141228
Installation Instructions – Cambria 201, 201-DC, 203
Mounting to Ground Spike
1.
Push fixture wires through the hole in the spike and
thread the fixture stem onto the spike.
2.
Connect fixture wires to the transformer wires
(polarity not critical).
3.
Plunge the spike into the ground at the desired
landscape location.
N
ote:
Lumiere ground spikes and other accessories need
to be ordered separately.
To Relamp
Spray socket with WD40. Do not use a lamp of higher
wattage than recommended.
MR11 and MR16 Bi-Pin: Unscrew the hood, pull lamp out.
Push new lamp in.
MR11 and MR16 D.C. Bayonet base: Push lamp into the
socket. Turn, pull the lamp out. Push new lamp into socket
by aligning pins on side of lamp with the slots in the sides
of the socket.
LED: Unscrew the hood. Remove the two 4-40 screws
and pull out the module. Install new module making sure
the LED pins are aligned with socket. Install two 4-40
screws making sure heat sink on the LED makes full
contact on the fixture base.
Do not over-tighten screws when replacing LED
module.
When replacing hood, make sure to not over tighten.
Doing so will compromise O-Ring seal and will void
warranty. Make sure hood is seated snug on O-Ring
www.eaton.com
10-32
Set Screw (B)
CAUTION
3
Publicité
