Publicité
Les langues disponibles
Les langues disponibles
ChefTop™ - BakerTop™
B. I NSTRUCTION FOR THE IN-
STALLER
1. WARNING
All the operations of installation, assembly, service and
assistance must be carried out by qualified personnel ac-
cording to current laws and regulations.
Please read carefully the instruction manual before the
installation and commissioning of the appliance.
The appliance must be unaltered (check for any trans-
port damage). Remove all informative material from the
chamber.
Avoid to modify the components sealed by the producer
with the intention of improving the performances of the
equipment; the producer refuses all responsibility for any
damage to persons or things that may be caused by an
improper use of the appliance and the warranty is auto-
matically invalidated.
The settings, the gas supply pressure values and the
technical data are indicated on CHART A of every oven
model.
2. PRELIMINARY OPERATIONS
2.1 INSTALLATION SITE
Before placing the appliance, please verify the overall di-
mensions and the exact position of the electrical and wa-
ter connections and of the fumes exhaust as indicated on
the attached file "Technical Data".
In particolar, check the earthing and the exhaust fumes
scavenging are in compliance with the safety.
Avoid to install the oven on places where there is a risk
of explosion.
Avoid to install the oven outdoor without a proper and
complete rain proof protection.
Avoid to install and use the oven inside small rooms where
there is insufficient air change.
2.2 PRESETTING FOR POSITIONING
You will find the feet inside the appliance.They must be
fitted to the oven.
Never use the appliance without its feet.
Remove the drip tray from the back of the oven by using
a screwdriver.
ENGLISH
ENGLISH
19
13
Place the oven on one side.
Insert the feet in the indicated positions and the tray
guides as shown in the picture.
2.3 REMOVAL OF THE PROTECTIVE FILM
Carefully remove all the protective film from the external
walls of the appliance.
Pay attention not to leave any residue of glue.If there
should be any residue of glue please remove it with an
appropriate solvent.
Remove the probe protection.
Publicité
