Télécharger Imprimer la page

Asist AE8G280DN Mode D'emploi page 61

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 64
The following table is used to refer to the connection of
the device to the petrol generator.
Typical
Example (kw)
model
Device
device
Bulb
100W
tv
Bulb
40W
Fluorescent
Fluorescent
lamp
lamp
Electric
drive
Refrigerator
Refrigerator
150W
Electric
ventilator
CLEANING AND MAINTENANCE
CAUTION: Before performing any maintenance, stop
the engine, allow it to cool, and disconnect the ignition
cable from the spark plug.
-! Do not replace generator parts, perform repairs
yourself, or otherwise interfere with the machine de-
sign. Product repair may only be performed by trained
personnel, resp. authorized service organization.
- Regularly check the generator for damage.
- Regularly remove dust and dirt from the generator
- Store the generator in a dry place and out of reach
of children.
- Never clean any part of the generator with a hard,
sharp or rough object.
- Cleaning is best done with a soft brush or cloth.
- When shutting down for a long time, remove the fuel
from the generator.
Oil change
- If the engine is warm (not hot)! - Remove the drain
plug and washer. Drain the oil into a suitable contai-
ner.
- Replace the washer and the drain plug.
- Place the generator on a level surface. Remove
the oil dipstick and pour new oil into the tank. Do not
overfill the oil tank.
Starting
Rated
(x1)
(x1)
100W
100W
(x2)
(x1.5)
80W
60W
(x3-6)
(x2)
450
300W
-750W
- Push the measuring cup back in and seal it.
- For a new engine, change the engine oil after the
first 5-8 hours of operation
CAUTION - Avoid excessive contact of your skin with
engine oil. Wear gloves when working and wash your
hands thoroughly after work!
Air filter
-! A dirty air filter prevents the passage of air, which
results in a reduction in engine power. Therefore,
clean the filter regularly.
- Remove the screws, remove the filter cover and
remove the filter
Remove the foam insert of the air filter, clean it well in
kerosene, squeeze and dry.
Gently moisten it with clean engine oil.
-! If the filter is torn, damaged or cannot be cleaned,
replace it with a new one.
Spark plug check
WARNING:
Before replacing or checking the spark plug, switch
off the engine and let it cool down!
The spark plug must be clean and with the correct
distance between the contacts to achieve efficient
engine operation.
Disconnect the cable connector from the spark plug.
Unscrew the spark plug using the spark plug wrench.
Do not use any other tools.
Visually inspect the spark plug. If it is damaged, repla-
ce it with a new one (recommended distance between
contacts is 0.70mm - 0.80mm). The recommended
type of spark plug is F6TC.
Do not bend the center electrode to change the gap.
Screw in the spark plug with a torque of 25 Nm - 30
Nm
! Improper tightening of the spark plug can result in
reduced engine power or permanent engine damage.
Fuel filter maintenance
Set the fuel cock to the „OFF" position.
Thoroughly clean the fuel filter container, blow it out
with compressed air in the direction of the arrow.
Firmly install the new rubber pad and filter bowl.
61

Publicité

loading

Ce manuel est également adapté pour:

Ae8g300dn