Program The Travel - LiftMaster 8500W Guide De L'utilisateur

Adjustment
1

Program the Travel

Without a properly installed safety reversal system, persons (particularly small children) could be SERIOUSLY
INJURED or KILLED by a closing garage door.
• Incorrect adjustment of garage door travel limits will interfere with proper operation of safety reversal system.
• After ANY adjustments are made, the safety reversal system MUST be tested. Door MUST reverse on contact with
1-1/2" (3.8 cm) high object (or 2x4 laid flat) on floor.
Note: While programming the travel, the UP and DOWN buttons can be used to move the door as needed. During the
Automatic Force Setup, the door will automatically open and close.
1
Press and hold the
Adjustment Button until
the UP Button begins
to flash and/or a beep
is heard. The Safety
Reversing Sensors will
be disconnected during
the Program the Travel
process.
3
Once the door is in the
desired UP position press
and release the Adjustment
Button. The garage door
opener lights will flash twice
and the DOWN Button will
begin to flash.
5
Once the door is in the
desired DOWN position press
and release the Adjustment
Button. The garage door
opener lights will flash twice.
Program the Travel is now
complete. If the garage door
opener lights flash 5 times,
then programming has timed
out and the Travel Limits have not been set. Please
restart the Program the Travel process.
2
Automatic Force Set Up
Once both the up and down positions have been manually set, the Safety Reversing Sensors will reconnect and become
operational. Then, the opener will enter a force-sensing operation by automatically moving the door open and close. The
garage door opener will sound an audible and visual alert before automatically opening and closing the door. The garage
door opener will beep three times, confirming that the Automatic Force Setup completed successfully. Adjustment is
complete.
If you hear one long beep after the door attempts to move, then the Automatic Force Set Up has not completed
successfully. Please start over at step 1 of Program the Travel.
14
2
Press and hold the UP Button until the door is in
the desired UP position.
4
Press and hold the DOWN Button until the door is in
the desired DOWN position.
For the complete manual visit LiftMaster.com/Customer-Support