Télécharger Imprimer la page

Tivoli Audio MUSIC SYSTEM+ Manuel D'utilisation page 9

Dab/dab+/dmb/fm/cd stereo tischradio mit bluetooth- wireless-technologie
Masquer les pouces Voir aussi pour MUSIC SYSTEM+:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 47
pressing the
button will re-start the currently playing track. Using these buttons during
shuffle play may cause tracks to repeat.
9. STOP: Press to stop CD playback and return to the first track.
10. PLAY/PAUSE: With a CD loaded, briefly press to initiate disc playback. Press during playback
to Pause playback and press again to resume playback. If the CD is paused for more than 5
consecutive minutes it will revert to Stop.
: Briefly press to fast forward or fast reverse in approximately 10 second intervals. Press
11.
again to resume normal playback or press Play. These functions are not on the remote control.
Due to the nature of MP3 CDs, using the fast reverse will cause the CD to stop playback once it
reaches the start of the track. Also note fast forward and fast reverse will not operate during CD
Intro mode. Pressing the fast scan buttons (
12. EJECT: Press to Eject a CD. The display will show "Ejecting". This button is to eject only and
should NOT be used to load a CD. Always remove the disc in a straight position with-out bending
the disc. In the unlikely event you experience an error or a disc remains stuck inside, discon-
nect the power cord for 60 seconds and reconnect firmly.
13. AUDIO: Push briefly to cycle through Stereo, SpacePhase
The SpacePhase
Wide mode setting is designed to create a more expansive soundstage,
while the Mono setting reduces multiplex noise on weak FM stations, making otherwise unlis-
tenable stations listenable. Regardless of the previous audio setting, the SpacePhase
mode will automatically engage each time the Music System+ is turned on.
EQ: To temporarily turn the EQ off, press and hold the Audio button. The display will show "EQ
Off" and a confirmation beep will sound. The EQ will engage again automatically the next time
the Music System+ is turned on. To keep the EQ off, press and hold the Audio button and the
display will show "EQ Always Off" and a confirmation beep will sound. The EQ will remain off
until "EQ On" is selected. The EQ differs from Audio in that it enhances lower frequencies
primarily at lower volume levels. We suggest the rear Bass level be set to the center detent
position. Should the bass ever sound distorted, immediately lower the bass level and/or volume.
14. INFO: When in DAB mode, briefly press repeatedly to view audio, signal strength, frequency,
signal error, and bit rate. In FM mode, view audio, signal strength, PTY (Program Type, if any)
and frequency.
15. SNOOZE/MUTE (Top of Cabinet): When the Alarm activates, press this button to silence the
alarm for 7 minutes. The display will count down the remaining Snooze time. Adjusting the
volume level will cancel the Snooze mode. During normal operation, press this button to mute
the audio. The display will show "Muted". Press again to restore the audio output or adjust the
volume level.
16. HEADPHONE OUT: Connect a set of headphones (not included) to this variable stereo output
for private listening. Plugging in the headphones will mute the primary speakers. The head-
phone's volume is adjusted using the front panel volume knob. This stereo output accepts
a 3.5 mm stereo male mini connector. Avoid using headphones at high volume levels to prevent
possible hearing damage.
17. OPTICAL SENSOR: Automatically adjusts the display brightness based on ambient lighting
conditions. The display will dim in darker environments and brighten in brighter conditions. Do
not obstruct this sensor.
18. IR SENSOR: Receives signals from the included remote control. Do not obstruct this sensor.
19. SLOT-LOAD: Insert a disc (with printing side facing up) until it is drawn inside. The display will
say "Loading". Disc functions will not work while the disc is loading. Playback will begin auto-
matically once the table of contents is read. The display will show "No Disc" when the unit is
set to CD mode and there is no CD inside. When ejecting a CD the display will show "Ejecting".
For more, see "Important Notes About the CD Player."
) during shuffle play may cause tracks to repeat.
Wide mode, or Mono audio settings.
Wide
9 – ENGLISH

Publicité

loading