Power Fist 8866659 Mode D'emploi page 12

8866659 9 Gallon Twin-Tank Wheelbarrow Portable Air Compressor
1. Attach the air hose to the air outlet (J).
2. Rotate pressure regulator knob (M) to the desired line pressure. Turning
the knob clockwise increases air pressure at the outlet; turning
counterclockwise reduces air pressure at the outlet.
a. If using an inflation accessory, control the amount of air flow with
the pressure regulator knob.
3. Always shut off the engine when the task is finished. Never leave the
compressor running while unattended.
4. Completely relieve the system of air pressure by pulling the ring on the
safety valve. Position yourself so that the expelled moisture and air is
not blown towards you. Continue to pull the ring until all air pressure
escapes. Depressurize the tanks completely.
5. Drain moisture from each air tank using the drain valve (K and L)
located on the underside. Only do this when the tanks pressure is 10
PSI or lower. Position the compressor so that the drain valve is lower
than the rest of the air tank. Drain until all moisture is removed. Leave
the valves open until the tanks have time to dry.
6. Disconnect the air hose from compressor and hang the open ends
down to allow any moisture to drain.
7. Store the compressor and hose in a cool, dry place.
CARE & MAINTENANCE
Consult the Gas Engine manual for engine maintenance instructions.
1. Maintain the tool with care. A tool in good condition is efficient, easier
to control and will have fewer problems.
2. Inspect the tool fittings, alignment, hoses and power supply cord
periodically. Have damaged or worn components repaired or replaced
by an authorized technician. Only use identical replacement parts
when servicing.
3. Follow instructions for lubricating and changing accessories.
4. Only use accessories intended for use with this tool.
5. Keep the tool clean, dry and free from oil/grease at all times.
6. Maintain the tool's labels and name plates. These carry important
information. If unreadable or missing, contact Princess Auto Ltd. for
replacements.
a. Do not operate this tool if it does not contain a legible warning label.
12 For technical questions call 1-800-665-8685
V1.0